nagios:nrpe.cfg
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
nagios:nrpe.cfg [2015/06/24 12:09] – jzaehrin | nagios:nrpe.cfg [2015/07/14 08:08] – jzaehrin | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | / | ||
< | < | ||
############################################################################# | ############################################################################# | ||
Line 96: | Line 97: | ||
# Values: 0=do not allow arguments, 1=allow command arguments | # Values: 0=do not allow arguments, 1=allow command arguments | ||
- | dont_blame_nrpe=0 | + | dont_blame_nrpe=1 |
Line 126: | Line 127: | ||
# Values: 0=debugging off, 1=debugging on | # Values: 0=debugging off, 1=debugging on | ||
- | debug=1 | + | debug=0 |
Line 174: | Line 175: | ||
# | # | ||
- | # | ||
Line 198: | Line 198: | ||
- | # The following examples use hardcoded command arguments... | + | # local configuration: |
+ | # if you'd prefer, you can instead place directives here | ||
+ | include=/ | ||
+ | # | ||
+ | # you can place your config snipplets into nrpe.d/ | ||
+ | # only snipplets ending in .cfg will get included | ||
+ | include_dir=/ | ||
+ | </ | ||
+ | |||
+ | / | ||
+ | < | ||
command[check_users]=/ | command[check_users]=/ | ||
command[check_load]=/ | command[check_load]=/ | ||
Line 206: | Line 216: | ||
command[check_watchdog]=/ | command[check_watchdog]=/ | ||
command[check_acdsn]=/ | command[check_acdsn]=/ | ||
- | command[check_time]=/ | + | command[check_time]=/ |
- | command[check_nix_firmware]=// | + | |
- | command[eh_time_full]=/ | + | command[eh_time_full]=sudo / |
command[eh_time_part]=/ | command[eh_time_part]=/ | ||
- | |||
- | # local configuration: | ||
- | # if you'd prefer, you can instead place directives here | ||
- | include=/ | ||
- | |||
- | # | ||
- | # you can place your config snipplets into nrpe.d/ | ||
- | # only snipplets ending in .cfg will get included | ||
- | include_dir=/ | ||
</ | </ |
nagios/nrpe.cfg.txt · Last modified: 2015/07/14 08:28 by jzaehrin