Differences

This shows you the differences between two versions of the page.

--- nagios:nrpe.cfg [2015/06/24 12:09] – jzaehrin
+++ nagios:nrpe.cfg [2015/07/14 08:28] (current) – jzaehrin
@@ Line 1: / Line 1: @@
+/etc/nagios/nrpe.cfg
 <code>
 #############################################################################
@@ Line 96: / Line 97: @@
 # Values: 0=do not allow arguments, 1=allow command arguments
-dont_blame_nrpe=0
+dont_blame_nrpe=1
@@ Line 126: / Line 127: @@
 # Values: 0=debugging off, 1=debugging on
-debug=1
+debug=0
@@ Line 174: / Line 175: @@
 #include_dir=<somedirectory>
-#include_dir=<someotherdirectory>
@@ Line 198: / Line 198: @@
-# The following examples use hardcoded command arguments...
+# local configuration:
+#	if you'd prefer, you can instead place directives here
+include=/etc/nagios/nrpe_local.cfg
+#
+# you can place your config snipplets into nrpe.d/
+# only snipplets ending in .cfg will get included
+include_dir=/etc/nagios/nrpe.d/
+</code>
+/etc/nagios/nrpe.d/commands.cfg
+<code>
 command[check_users]=/usr/lib/nagios/plugins/check_users -w 0 -c 0
 command[check_load]=/usr/lib/nagios/plugins/check_load -w 60,40,20 -c 80,60,40
@@ Line 206: / Line 216: @@
 command[check_watchdog]=/usr/lib/nagios/plugins/check_procs -C watchdog -c 1min:
 command[check_acdsn]=/usr/lib/nagios/plugins/check_procs -C acdsn -c 1min:
-command[check_time]=/usr/lib/nagios/plugins/check_ntp_time -H ntp.metas.ch
+command[check_time]=/usr/lib/nagios/plugins/check_ntp_time -H 0.debian.pool.ntp.org -t 30
-command[check_nix_firmware]=//bin/bash /home/acdsn/git/acdsn-scripts/nix_firmware.sh $ARG1$
-command[eh_time_full]=/home/acdsn/git/acdsn-scripts/set_time.sh -b >/dev/null 2>&1
+command[eh_time_full]=sudo /home/acdsn/git/acdsn-scripts/set_time.sh
 command[eh_time_part]=/bin/bash /home/acdsn/git/acdsn-scripts/broadcast_time.sh -a $ARG1$
-# local configuration:
-#	if you'd prefer, you can instead place directives here
-include=/etc/nagios/nrpe_local.cfg
-#
-# you can place your config snipplets into nrpe.d/
-# only snipplets ending in .cfg will get included
-include_dir=/etc/nagios/nrpe.d/
 </code>