This is an old revision of the document!

ACDSN-C-FX

The following line shows how to address and communicate with a NiX1 slave over a RS485 line.

 1Qw3
 ^^^^
 ||||
 |||- option
 ||-- argument
 |--- command
 ---- address

Commands

Label	Command
new	N
query	Q

Label	Arguments	Options	Comments
new address	a	<address>	change address
new buzzer mode	b	<mode>	buzzer activated or not
new contact mode	c	<contact>\t<mode>	set contact NO/NC mode
new discontinuation	d	<discontinuation>	set the timeout value after which the slave consider itself to be abandoned by the server
new limit	l	<ow>\t<limitH>\t<limitL>	set alarm boundaries
new mode	m	<device>\t<mode>	slave/device enable/disable
new recess	r	<recess>	scan-rate interval
new timestamp	t	<timestamp>	only if RTC defined (used to synchronize clock)
new wire	w	-	scan the lines and return the number of OW device found

Label	Arguments	Options	Comments
query buzzer status	b
query contact status	c
query discontinuation status	d		no query from server timeout
query family	f	<ow>	get the 1-wire family of device n
query mode	m	0 (zero)	slave active or not
		<contact>	contacts active or not
		<ow>	OW devices active or not
query recess	r		scan-rate intervall
query status	s	0 (zero)	global status
		<contact>	contacts status
		<ow>	OW devices status
query timestamp	t		only if RTC is defined
query value	v
query wire	w	0 (zero)	tel the number of OW devices connected
query wire	w	<ow>	return the OW SID